UltraClear Super Strength Treatment - SST 32 oz (MPN 46000)

UltraClear SST is a powerful treatment specifically formulated to improve water quality in ponds that are plagued by severe clarity problems. These issues are often caused by the presence of dense mats of long filaments and scum floating on the surface of the pond. These mats can easily break apart, making them difficult to remove with a net. Additionally, their decay contributes to the accumulation of suspended solids in the water that cannot be easily eliminated. To combat these problems, UltraClear SST is enriched with a combination of safe and beneficial bacteria. These natural clarifiers consume the nutrients that promote unwanted growth, effectively targeting and resolving cloudy water at its source. The dosage of UltraClear SST should be determined based on the volume of water in your pond. In general, you should use 1 ounce of the product for every 150 gallons of pond water. The frequency of dosing will vary depending on the specific circumstances. If you are using it as a preventative measure, start dosing UltraClear SST before experiencing any issues and repeat the treatment once a month during the months when blooms or growth typically occur. For existing problems, dose once a week until the problem is resolved, then switch to monthly dosing or as needed. In severe cases, daily dosing may be required until improvements are observed, after which you can switch to weekly dosing. It is important to note that overdosing will not harm your pond, but it is essential to understand that biological solutions take longer to produce results compared to chemical techniques. By following the recommended dosage guidelines, you can achieve optimal and efficient outcomes without wasting product. For best results, mix the required dose of UltraClear SST into a gallon of pond water, thoroughly shake or mix the solution, and evenly distribute it throughout the pond. Concentrate larger amounts of the product in the areas where the problem is most severe.